Design Creations Photo Gallery

Projects, products and stuff DC has created.

     
 
Home / Replicas - Props / STA-52 from Killzone /

PXL 20240616 163918931

PXL_20240616_163918931.jpg PXL 20240616 071447893ThumbnailsPXL 20240616 163914370PXL 20240616 071447893ThumbnailsPXL 20240616 163914370PXL 20240616 071447893ThumbnailsPXL 20240616 163914370PXL 20240616 071447893ThumbnailsPXL 20240616 163914370PXL 20240616 071447893ThumbnailsPXL 20240616 163914370PXL 20240616 071447893ThumbnailsPXL 20240616 163914370PXL 20240616 071447893ThumbnailsPXL 20240616 163914370

I pulled the casing into 3DS Max and cut some slots around the outer diameter. I'll give this a shot. If anything I have a couple thin clear acrylic sheets I can cut and wrap and glue inside the cylinder.

I'll see how that looks. If it is too terrible than I'll try some "clear" PLA I found on Amazon.

Rate this photo

0 comments